I’d like to find a way to mount the board in a plastic project box. This doesn’t have to be perfect or all that clean – just good enough, and removable, I’ll use anything that works. Does anyone have any suggestions?
Velcro might be easy to put it in with, and also be easy to remove it again.
Thanks MikeDK.
Ok so I’m thinking maybe I’ll cement some non-conductive foam in the case, and then use gorilla tape “straps” to hold it down against the foam. Removable, and pretty strong.
perhaps someone in the 3d printing/thingieverse community could come up with a base design, I’m thinking in the same way as they did for raspberry PI
Like this?
…though that’s really just for the april board…