Hi i made a pcb board exactly like the april board and inserted the electric imp1 card into it but

hi
i made a pcb board exactly like the april board and inserted the electric imp1 card into it
but still not able to run the code and the device is offline in the code always

Thank you
ankit

What’s the mac address of the device?

Do you have the ATSHA204A stuffed correctly?

thank you my design of the board is based on this design basically giving the imp a stable voltage regulation https://cdn.sparkfun.com/datasheets/Wireless/WiFi/electric-imp-breakout-v12.pdf

i have stuffed ATSHA204A correctly but how to get the mac address

what i have done is remove the exisitng ATSHA204A ic from the april board and add it into the new hardwre is that ok ?

mac address of the imp i am using is 0c2a69002582

So, I can see that MAC address online. It’s inserted into a device with the impee ID 23504c3643fc42ee and appears to be booting a model called “ind”?

Note that if you moved the ATSHA from the April to this board, then you will not see a new device appear. As far as the imp is concerned, it’s still plugged into your old April board because the ID is the same.