Getting Started

Following the getting started tutorial. Code runs successfully, led does not blink. Have swapped all hardware components to weed out busted components as the issue. Help?

Not sure of your familiarity with the imp or electronics, so please forgive the questions if they’re too basic.

  • how do you know your code is running successfully?
    (have you included a couple of server.logs() to see if things are running?)
  • I assume you’re using an April (or equivalent) with the resistor/LED on pin 9?
    … have you observed correct polarity for the LED?
  • do you have any other means of observing activity on the output pin …
    i.e. a scope or multimeter?

Again, apologies if you’ve already taken care of the basics here.