I have the following simple code to check if my BMG113 device (connected to an imp005 board) is being successfully being configured.
The device is connected through uart0. I have this simple code to check if the FIFO data is being stored in the buffer or not:
var <- hardware.uart0;
var.configure(115432, 8, 0, 1, 0);
The value in the log always shows -1 despite choosing different value settings and even the other 2 available board pins (uart1 and uart2), meaning FIFO is empty. Is it correct to assume that the device isn’t connected?
Is it possible that it might be physically connected but unable to be read because of some firmware issue?
Thanks for your time,